Trying to install the QuickTake 200 driver on my PowerMac

[krye]

I'm trying to install the QuickTake 200 driver on my PowerMac 5200. My QT 200 never came with the software CD. I hit up Apple's vintage support section, but the driver they have on there is for the QuickTake 100.

I only managed to find one other site that has the driver. I downloaded it onto a floppy and ran the installer on my PowerMac. The installer starts, but it complains that I'm using the wrong disk and it doesn't let me proceed. It spits out the disk.

I've titled the disk appropriately. When I reinsert the disk it tells me that although it's named correctly, it's the wrong disk But that's the disk I'm running the installer from. I even copied it to the hard drive and ran it from there. It does that same thing.

Does anyone have the QuickTime 200 installer they can link me to / PM?

Thanks.

[krye]

I got the driver. Installed it now. Just trying to get the camera to connect now.

[mcdermd]

That desktop picture is killer. Where did you find it?

[krye]

This wallpaper site here:

http://designrfix.com/freebies/50-beaut ... wallpapers

[krye]

Well, I got the software installed. I hooked up the camera to the Printer and the Modem ports without any luck. The utility just complains that it can't find a camera. It suggests shutting off AppleTalk. I did that but it still says it can't find a camera. I have the QuickTake in "PC mode", still nothing.

Using a PowerMac 5200 with OS 8.6. Any suggestions?